Folks, When the box failed to boot, you might remember, it complained that the kernel was "too old". I remade the box using the newer kernel 2.6.20. I apparently configured the correct silo.conf (there are five of them in there when using the livecd). It looked like it was going to BOOT!! :-) See below..... Trouble is this is as far as it got. I printed and used as reference the Gentoo Linux 2006.1 SPARC Handbook, the Using UTF08 with Gentoo document and the Gentoo Upgrading Guide. Nevertheless I had a very difficult time with manual configuration of the kernel. I had not the faintest idea which modules I could ignore and which I needed to modularize Question: is there a log somewhere? I did emerge syslog-ng. Another question: Where is the detailed documentation on all the modules? Final question: How do I get a hint at what I did wrong? Ken ----------------snip of hyperterminal watching SUN ULTRA boot.------------ Sun Ultra 1 UPA/SBus (UltraSPARC 200MHz), No Keyboard OpenBoot 3.11, 192 MB memory installed, Serial #9633364. Ethernet address 8:0:20:92:fe:54, Host ID: 8092fe54. Initializing Memory \ Initializing Memory \ Initializing Memory \ Initializing Memory - Initializing Memory - Boot device: disk File and args: SILO Version 1.4.13 boot: Allocated 8 Megs of memory at 0x40000000 for kernel Loaded kernel version 2.6.20 Remapping the kernel... done. Booting Linux... -----------------------------------end snip-----------------------------