Thanks! That gets me a little bit further. After verifying the device exists, I chmod to get permission for /dev/pilot (which is ln'ed to /dev/ttyUSB0). Now when running the gnome-pilot setup, the palm connects, but the setup app doesn't see it. Again, thanks for your help! It's gotten me a little closer to the goal! Walt On Sun, 2005-10-30 at 12:07 +0100, Karl Hiramoto wrote:
ls -la /dev/ttyUSB0 verify that the device exists there, and that you have read/write permissions. I use gentto, so I'm not sure how fedora handles devices. If they use udev, devfs, etc.
Walt Sawyer wrote:
Thanks! After checking dmesg, I created a link: ln /dev/ttyUSB0 /dev/pilot Still, no connection.
usbcore: registered new driver usbserial drivers/usb/serial/usb-serial.c: USB Serial support registered for Generic usbcore: registered new driver usbserial_generic drivers/usb/serial/usb-serial.c: USB Serial Driver core v2.0 drivers/usb/serial/usb-serial.c: USB Serial support registered for PL-2303 pl2303 1-3.2:1.0: PL-2303 converter detected usb 1-3.2: PL-2303 converter now attached to ttyUSB0 usbcore: registered new driver pl2303 drivers/usb/serial/pl2303.c: Prolific PL2303 USB to serial adaptor driver v0.12 On Sat, 2005-10-29 at 23:29 +0200, Karl Hiramoto wrote:
What is the output of "dmesg" It probally created a serial device in /dev/tts/USB0 or something like that.. The prolific USB-Serial adapter just acts like a plain old rs-232 serial port. Then you need application software to sync.
Walt Sawyer wrote:
Hi all, I need some help! I bought a USB to Serial/parrallel adaptor (IBM 22P5298). Fedora 4 seems to see it in /proc/bus/usb/devices but when I try to hotsync my palm, no connection results. Anyone have an idea as to how to proceed? Thanks in advance! Walt
Below is part of the output of more /proc/bus/usb/devices
T: Bus=01 Lev=02 Prnt=07 Port=01 Cnt=02 Dev#= 9 Spd=12 MxCh= 0 D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1 P: Vendor=067b ProdID=2303 Rev= 3.00 S: Manufacturer=Prolific Technology Inc. S: Product=USB-Serial Controller C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA I: If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=00 Prot=00 Driver=pl2303 E: Ad=81(I) Atr=03(Int.) MxPS= 10 Ivl=1ms E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms E: Ad=83(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms
_______________________________________________ Wlug mailing list Wlug@mail.wlug.org http://mail.wlug.org/mailman/listinfo/wlug
_______________________________________________ Wlug mailing list Wlug@mail.wlug.org http://mail.wlug.org/mailman/listinfo/wlug