I have a RH7.0 server which has been giving me regular unrecoverable disk errors since 6-8 weeks ago. I figured today I had enough time to do something about it. I also figured that as long as I had to rebuild from scratch (after installing a new hard drive) I'd upgrade to RH7.3 -- but I have a few more problems that I figured on. The server is dual homed - eth0 (DEC 2104x 10mbps tulip driver) goes to DSL, eth1 (Realtek 100mbps) goes to internal network. Was running IP Masquerade / IPChains / Apache / sendmail / DNS server fine under RH7.0 I have the following problems: 1) During startup eth0 comes up but eth1 does not. My notes on the previous installation [year ago?] don't show that I did anything special when I installed the Realtek (was previously also DEC 2104x) but that doesn't mean I just didn't write it down. 2) dhcpd won't run, but I assume that's related to #1. Was surprised that dhcpd wasn't loaded during install, as I flagged eth1 as dhcp. 3) how do I know whether IPchains or IPtables is active, and how do I switch. Considering the time involved so far, I think I'd rather delay switching to IPTables and use my existing IPChains firewall for now. Can I still hook it in at the end of rc.local? 4) During install I did answer some firewalling questions (set to medium, custom) -- where is the results of that dialog? 5) If I can use my existing IPChains firewall, that will take care of IP Masquerade -- if not can I have some guidance as to what direction to take. 6) httpd comes up but says "cannot resolve hostname, using 127.0.0.1" - what did I forget to configure? (I haven't touched httpd.conf yet.) 7) issue and issue.net used to be set from rc.local, but no more -- where are they set? I'd like to patch that out and be a bit more anonymous. I'm definitely unconnected until most of these Q's get resolved. Thanks to any who can assist me. Dick