Jeff Kinz wrote:
On Thu, Sep 16, 2004 at 05:30:21PM -0400, track@trackspace.com wrote:
Thank you for all that responded. I'll try to summarize the answers to all the follow-up questions in one reply.
When I turn the power on, nothing happens except a red LED on the motherboard lights up. The CPU fan doesn't spin, the computer doesn't beep - nothing (so no beeps or POST codes). The weird thing is that when I turn the power switch off, the LED stays lit for another 5-6 seconds. I'm not sure if that means anything though...
That's just the capacitance stored up in the MB caps. That's the reason people say to wait 10 seconds between powering off and powering on. This also would seem to be a sign that the PS is feeding power.
Do the power supply fans spin?
I assume not, since he says above "nothing happens" :-)
the Abit NF7 with MB LEDs has two power LEDs - the red one, when lit, indicates standby by power. The green one, when lit, indicates the machine is powered up.
You seem be stuck in standby mode. Try the front panel power switch a few times. (Count to 10 between each try, see if green MB LED turns on)
Good point. Maybe this is what you meant but also try holding the button for 5-10 seconds as well.
If that doesn't work, try "aggressively" using the front panel switch. Sometimes the front panel switch start to fail and they have a hard time turning on the signal that tells the system to power up.
Just trace the switch wires back to the MB jumper header then manually jumper the connection yourself. If there are 2 wires the jump is obvious--3 wires you may want to check the MB manual to make sure you jump the right ones. Only need to jump briefly...this will eliminate the switch as the culprit. Also try unplugging the PS from the wall for 30 sec to cold cycle everything. Also, you can check the PS simply enough (assuming it's an ATX): -unplug it from the MB (leave at least one HDD connected for a load...PS will power off if no load) -compare the MB connector to the one here: http://xtronics.com/reference/atx_pinout.htm -if the same, jump (with paper clip...be careful!) pin 14 to 15 together -PS should power on (fan(s) spin, HDD(s) spin up)
I stopped in at a computer shop on 122A in Holden this afternoon and was quoted a $35 "bench fee" for taking a look at it and $75/hr to do any work. Like I said before, all the parts are still under warranty through New Egg and I'd happily send them back but I need to figure out what's not working.
Forget PC shops, IMO...they're only going to do the simple tests you can find on lists like these anyway ;-) BR