Someone must have been sending me telepathic messages. I finally thought to check sax --help, and I was able to get it to run using switches for hsync, vsync, and X-server, and it worked. In fact, I think the screen looks better than it did before. Xfree 4.0 doesn't appear to be on the 7.2 disks. There's a 4.0 glx driver, and there's glx-devel package, but no basic package. Anyway, it's working. Thanks. Greg avedis@rcn.com wrote:
Hi Andy,
Here's my hardware: 1.2GHz Athlon on a Spacewalker AK12A motherboard ELSA GLoria-L vid card (16MB), which has S3virge chip with Glint 500TX, and uses the 3DLabs driver.
At some point last year, I thought I installed XFree 4.1 and got the 3DLabs driver. That's what my notes say. But 3.3.6 was running. If I can install 4.0 from the disks, I'll try it. Every time I've run sax, most of it runs off-screen, and I can't use it. That might be where I screwed up yesterday, by hitting Enter when I shouldn't have.
Thanks, Greg
On 22 Dec 2002, at 22:34, Andy Stewart wrote:
HI Greg,
On SuSE, they supply version 3.3.6 and 4.0.x of XFree86. Most of the time, you want to run version 4.0, but if you have "vintage" video hardware, you're better off with version 3.3.6 in my opinion.
To configure XFree86 on SuSE, you should be running sax (for XFree86 version 3.3.6) or sax2 (for XFree86 version 4.0).
If you look at your log (below), you'll note that for some reason, you're running XFreee86 version 3.3.6. Just what do you have for video hardware?
I've found on SuSE that you're generally better off if you let YaST do the "dirty work" for you.
Later,
Andy
On Sunday 22 December 2002 6:36 pm, avedis@rcn.com wrote:
Here's the error message I get when I try to run startx:
XFree86 Version 3.3.6 / X Window System (protocol Version 11, revision 0, vendor release 6300) Release Date: January 8 2000 If the server is older than 6-12 months, or if your card is newer than the above date, look for a newer version before reporting problems. (see http://www.XFree86.Org/FAQ) Operating System: Linux 2.4.4-64GB-SMP i686 [ELF] SuSE Configured drivers: GLINT: accelerated server for 3DLabs GLINT graphics adapters (Patchlevel 0) (using VT number 7)
XF86Config: /etc/XF86Config (**) stands for supplied, (--) stands for probed/default values (--) no ModulePath specified using default: /usr/X11R6/lib/modules dbe: Unknown error loading module
Config Error: /etc/XF86Config:48
-- Andy Stewart, Founder Worcester Linux Users' Group Worcester, MA USA http://www.wlug.org
_______________________________________________ Wlug mailing list Wlug@mail.wlug.org http://mail.wlug.org/mailman/listinfo/wlug
_______________________________________________ Wlug mailing list Wlug@mail.wlug.org http://mail.wlug.org/mailman/listinfo/wlug